![]() ![]() This alteration was the design of William Wentzel, starting in about April of 1862 throughout the course of the war. These plates measure approximately 1 5/8″ from the top of the hump area of the lock plate to the bottom of the plate. ![]() Type 4: Lock plates that used retooled dies and reconfigured the high hump design lock plate to what most call a low hump. Type 3: Lock plates were lock plates (high humps) that the hump on the plate was either cut or grinded down to allow the user to quickly insert and remove the primer, since the hump usually got in the way, slowing down the loading time of even the best foot soldier. indicating they were weapons that were made after the Armory was transferred to the Confederate Government. Type 2: Were similar too type 1( high humps) except they would be stamped with C.S. Unfortunately I do not have an example of this type of lock plate. ![]() These Richmonds were made before the Armory was transferred to the Confederate Government and were not stamped with the C.S. Type1: Would be the high hump lock plates that were stamped 1861 to the left of the hammer and Richmond, Va to the right side. Richmond Lock Plates come in a number of different types. Type 4,3,2ġ863 Richmond Low Hump Lock Plates. 1862 Richmond High Hump Lock Plate, Type 2ġ864 Richmond Low Hump Lock Plate, Type 4ġ862 Richmond Lock Plates, Top to Bottom. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |